美利体育登录入口官网

半导体器件的机械标准化.表面安装半导体器件封装外形图绘制的一般规则.P-VSON的尺寸

Mechanical standardization of semiconductor devices - Part 6-10:General rules for the preparation of outline drawings of surface mounted semiconductor device packages - Dimensions of P-VSON

米制锥形外螺纹和配对圆柱形内螺纹.第1部分:公称尺寸.极限偏差.极限尺寸和验证

Metric external taper screw threads and mating internal parallel screw threads - Part 1: Nominal sizes, limit deviations, limits of size and verification

商用车驾驶室外部凸出物

External protrusions on the cab of commercial vehicles

客车车内尺寸

Bua inner dimensions

米制密封螺纹

Metric threads where pressure-tight joints are made on the threads

体操器械.体操垫

Gymnastic equipment.Gymnastic mats

60°干密封管螺纹

Dryseal pipe threads with the thread angle of 60 degrees

硅片弯曲度测试方法

Test method for bow of silicon wafers

55°密封管螺纹 第2部分:圆锥内螺纹与圆锥外螺纹

Pipe threads with 55 degree thread angle where pressure-tight joints are made on the threads Part 2:Taper internal and external threads

球栅阵列(BGA)试验方法

Ball Grid Array (BGA) Test Method

农用拖拉机.重心位置的测定

Agricultural tractors. Measurement of the centre of gravity position

关于审核商用车辆驾驶舱后板前方的外部凸出物的统一规定

Uniform provisions concerning the type approval of commercial vehicles with regard to their external projections forward of the cabins rear panel

电子美利体育官网首页网址机械结构研制用模数序列. 第2部分. 分规范. 25 mm美利体育官网首页网址接口配合尺寸

Modular order for the development of mechanical structures for electronic equipment practices. Part 2. Sectional specification. Interface coordination dimensions for the 25 mm equipment practice

车辆人体工程学.机动车的手控装置,指示器和信号装置的位置

Ergonomics of vehicles. Location of hand controls, indicators and tell-tales in motor vehicle

表面贴装半导体器件的共面性测试

Coplanarity Test for Surface-Mount Semiconductor Devices

几何产品规范（GPS） 平面度 第1部分：平面度的术语和参数

Geometrical product specifications (GPS) -- Flatness -- Part 1: Vocabulary and parameters of flatness

（R）碰撞修复的统一参考和尺寸指南

(R) Uniform Reference and Dimensional Guidelines for Collision Repair