
点击查看大图
本标准规定了用作光源的光传输用半导体激光器(不包括内置电子电路的类型;以下简称半导体激光器)的术语、分类、最大额定值和性能等一般通用事项。
| 术语 | |
|---|---|
| 绝对最大额定值 | absolute maximum rating |
| 存储温度 | storage temperature |
| 环境温度 | ambient temperature |
| 工作温度 | operating temperature |
| 阈值电流 | threshold current |
| 辐射功率 | radiant power |
| 工作电流 | operating current |
| 工作电压 | operating voltage |
| 阈值辐射功率 | radiant power at threshold |
| 微分效率 | differential efficiency |
| 纵模 | longitudinal mode |
| 模间距 | mode spacing |
| 纵模数量 | number of longitudinal modes |
| 峰值发射波长 | peak emission wavelength |
| 中心发射波长 | central emission wavelength |
| 光谱带宽 | spectrum bandwidth |
| 发射源尺寸宽度与高度 | emission source seize width and height |
| 两个指定平面内的半强度角 | half-intensity angle in two specified planes |
| 偏振比 | polarization ratio |
| 边模抑制比 | side-mode suppression ratio |
| 光谱线宽 | spectral linewidth |
| 上升时间 | rise time |
| 下降时间 | fall time |
| 开启时间 | turn-on time |
| 关闭时间 | turn-off time |
| 开启延迟时间 | turn-on delay time |
| 关闭延迟时间 | turn-off delay time |
| 截止频率 | cut-off frequency |
| 相对强度噪声 | relative intensity noise |
| 高次谐波失真 | higher harmonic distortion |
| 复合二阶失真 | composite second-order distortion |
| 复合三阶拍频失真 | composite tripple-beat distortion |
| 载噪比 | carrier to noise ratio |
| 监控电流 | monitor current |
| 监控光电二极管暗电流 | dark current of monitor photodiode |
| 监控光电二极管电容 | monitor photodiode capacitance |
| 监控光电二极管上升时间 | rise time of monitor photodiode |
| 监控光电二极管下降时间 | fall time of monitor photodiode |
| 跟踪误差 | tracking error |
| 放大器 | 用于处理光电二极管输出的信号,测量相对强度噪声。 |
| 光电二极管 | 用于测量光功率波动和相对强度噪声的光接收元件。 |
Copyright ?2007-2026 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号
页面更新时间: 2026-07-06 16:24