| 术语 | 描述 |
|---|---|
| 每个试件面的浸渍消耗量 Consumption of impregnation per face of a test cube | Cn,处理期间每个试件面的浸渍消耗量 |
| 平均浸渍消耗量 Average consumption of impregnation | Cm,处理期间的平均浸渍消耗量 |
| 储存前试件质量 Mass of test cube before storage | d0,气候室储存前试件的质量 |
| 初始调节后试件质量 Mass of test cube after initial conditioning | d1,气候室初始调节后试件的质量 |
| 干燥试验结束时试件质量 Mass of test cube at end of drying test | d2,干燥试验结束时试件的质量 |
| 干燥速率系数 Drying Rate Coefficient | DRC,干燥速率系数 |
| 处理试件的干燥速率 Drying rate of a treated test cube | Dt,处理试件的干燥速率 |
| 三个处理试件的平均干燥速率 Average drying rate of three treated test cubes | Dtm,三个处理试件的平均干燥速率 |
| 未处理试件的干燥速率 Drying rate of an untreated test cube | Du,未处理试件的干燥速率 |
| 三个未处理试件的平均干燥速率 Average drying rate of three untreated test cubes | Dum,三个未处理试件的平均干燥速率 |
| 调节后的估计含水率 Estimated moisture content after conditioning | M't,调节后每个试件的估计含水率 |
| 三个烘箱干燥试件的平均含水率 Average moisture content of three oven-dried test cubes | Mm,三个在饱和水、表面干燥状态下的烘箱干燥试件的平均含水率 |
| 饱和水、表面干燥试件的含水率 Moisture content of water-saturated, surface-dry test cubes | Mssd,饱和水、表面干燥试件的含水率 |
| 估计的烘箱干燥质量 Estimated mass in oven-dry state | W'od,试件在烘箱干燥状态下的估计质量 |
| 烘箱干燥状态下试件的质量 Mass of a test cube in oven-dry state | Wod,烘箱干燥状态下试件的质量 |
| 饱和水、表面干燥状态下试件的质量 Mass of a test cube in water-saturated, surface-dry state | Wssd,饱和水、表面干燥状态下试件的质量 |
| 调节后的实际试件质量 Actual mass of test cube after conditioning | Wt,调节后试件的实际质量 |
| 处理前试件的质量 Mass of a test cube immediately before treatment | Wt1,处理前试件的质量 |
| 处理后试件的质量 Mass of a test cube immediately after treatment | Wt2,处理后试件的质量 |
| 天平 误差限 0.01 g | 用于称量试件。 |
| 培养皿 直径 150 mm | 用于在处理过程中支撑试件。 |
| 干燥器 含硅胶 | 用于冷却干燥后的试件。 |
| 气候室 温度 (30 ± 2) °C,相对湿度 (60 ± 10) % | 用于维持储存条件。 |
| 鼓风干燥箱 工作温度 (105 ± 5) °C | 用于干燥试件。 |
Copyright ?2007-2026 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号
页面更新时间: 2026-08-29 08:31